AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Mm ruler printable1/18/2024 Make sure to select the appropriate version for your test. It is important to note that each method has two versions: one for a direct drive extruder and one for a Bowden extruder. Each method has its own advantages and disadvantages. Orca Slicer includes three approaches for calibrating the pressure advance value. ** Remember ** to save the filament profile. In this case, if your previous flow ratio was 1.029 and you selected the block with a flow rate modifier of -6, the new value should be calculated as follows: 1.029x(100-6)/100 = 0.96726. The flow rate modifiers for this project will range from -9 to 0. This process is similar to Pass 1, but a new project with ten blocks will be generated. ** Remember** to save the filament profile. If your previous flow ratio was 0.98 and you selected the block with a flow rate modifier of +5, the new value should be calculated as follows: 0.98x(100+5)/100 = 1.029. ![]() Update the flow ratio in the filament settings using the following equation: FlowRatio_old*(100 + modifier)/100. Slice and print the project.Įxamine the blocks and determine which one has the smoothest top surface. ![]() Select the printer, filament, and process you would like to use for the test.Ī new project consisting of nine blocks will be created, each with a different flow rate modifier. Flow rate NOTE: For Bambulab X1/X1C users, make sure you do not select the 'Flow calibration' option.Ĭalibrating the flow rate involves a two-step process. NOTE: After completing the calibration process, remember to create a new project in order to exit the calibration mode.
0 Comments
Read More
Leave a Reply. |